Zenfone Max Pro (M2) {xo1bda} flashing error

i have recived from the costumer on hang on logo after tried with some frimweras also not done getting errors contentiously plz help me from this

hear some of i tried log

read info

Operation : Read Information
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM8)
Driver Info : HS Corporation, ghsser.sys, 10.2104.1.2
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1C00800 [8996] 00000000
OPK_DATA : 04F8AD2AD41FE15957014A0DC1F60E754590A340DC25378C8F 0674003492FCF4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_025]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 64 GB
LU Count : 1 [0x0747C000]
Payload Info : In: 262144 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : asus ASUS_X01BD [ASUS_X01BD]
Brand : asus
Prod.Name : WW_X01BD
Software : PKQ1.WW_Phone-16.2017.2009.097-20200826, 16.2017.2009.097-20200826 [Wed Aug 26 17:55:55 CST 2020]
Android Ver. : 9
Patch Level : 2020-09-05
USERDATA : Encrypted
You can use DISABLE LOCKS to Disable Pin/Pattern/Password WITHOUT Data Loss.
Operation Finished.
QcFire Ver. 6.1



After this i tried with this frimwear wear but also some errors i got like this

Ch_Sameer

ASUS X01BDA {Max Pro M2} Dead Unbrick Firmware Here

[firmware27]ZQL1820_Factory_201812071630_ChangeFlash.zip

Getting error like this

Operation : Flash
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM8)
Driver Info : HS Corporation, ghsser.sys, 10.2104.1.2
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1C00800 [8996] 00000000
OPK_DATA : 04F8AD2AD41FE15957014A0DC1F60E754590A340DC25378C8F 0674003492FCF4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_025]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 64 GB
LU Count : 1 [0x0747C000]
Payload Info : In: 262144 [4096], Out: 131072, Sector Size: 512
Writing [xbl.elf] -> [xbl] ...Failed
Operation Finished.
QcFire Ver. 6.1

I TRIED WITH SOME FIRMWARE ALSO BUT SAME ERRORS PLZ HELP ME FROM THIS FRIENDS


THANQ