Please Need Firmware Huawei Y7 2019 DUB-LXI

Please Need Firmware flash with UMT

Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM32)
Driver Info : HS Corporation, ghsser.sys, 10.2104.1.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1A00900 [8953] 65001500
OPK_DATA : 3B48AE9023196AE5C8162BCE65CB66E9636C784CB52A55046D 15110FD8B11688
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8953_030]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8953, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
Payload Info : In: 262144 [4096], Out: 16384, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : unknown
Software : System 8.2.0.036(05T4) [Wed Jul 17 02:03:12 CST 2019]
Android Ver. : 8.1.0
Patch Level : 2019-06-01
USERDATA : Encrypted
You can use DISABLE LOCKS to Disable Pin/Pattern/Password WITHOUT Data Loss.
Operation Finished.
QcFire Ver. 5.9